Heck no, it is not tough at all. You can use a dremel then knock them out
with a drift. I was surprised how easy it was.
Rascal
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of
snickzip-dml@yahoo.com
Sent: Sunday, June 17, 2007 5:59 PM
To: dakota-truck-moderator@bent.twistedbits.net
Subject: DML: Upper Ball Joint Replacement
I need to replace the upper ball joints on my 1999 4WD Dakota. I purchased a
pair of Moog ball joints to have a local shop install them. I'm starting to
have second thoughts and thinking about doing it myself. It doesn't appear
to
be that difficult a job aside from removing the rivets on the old ones.
What's
the easiest way to remove the rivets? Can I use a dremel tool to cut the
heads
off? Besides the rivets is there anything else difficult in the process or
anything I should be aware of? Thanks for any help.
Bob
This archive was generated by hypermail 2b29 : Sun Jul 01 2007 - 21:47:16 EDT