I agree, I would never do that to my Dremel. I don't believe they make any
attachments to really do that job. An angle grinder seems to work best. Biff
----- Original Message -----
From: "Brian" <hskr@san.rr.com>
To: <dakota-truck@dakota-truck.net>
Sent: Sunday, June 17, 2007 10:24 PM
Subject: DML: RE: Upper Ball Joint Replacement
>
> I wouldn't suggest a dremel. It would work, but would take a while. I
drilled mine out and used a punch to knock them through. I've done another
set where I had an angle grinder and ground the heads off. The grinder
worked much faster.
>
> brian cropp
> -----Original Message-----
> From: owner-dakota-truck@bent.twistedbits.net
> [mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of
> snickzip-dml@yahoo.com
> Sent: Sunday, June 17, 2007 3:59 PM
> To: dakota-truck-moderator@bent.twistedbits.net
> Subject: DML: Upper Ball Joint Replacement
>
>
> I need to replace the upper ball joints on my 1999 4WD Dakota. I purchased
a pair of Moog ball joints to have a local shop install them. I'm starting
to have second thoughts and thinking about doing it myself. It doesn't
appear to be that difficult a job aside from removing the rivets on the old
ones.
> What's the easiest way to remove the rivets? Can I use a dremel tool to
cut the heads off? Besides the rivets is there anything else difficult in
the process or anything I should be aware of? Thanks for any help.
>
> Bob
>
This archive was generated by hypermail 2b29 : Sun Jul 01 2007 - 21:47:16 EDT