I bought an HO manifold with a TB attached, for a mere
$55.00......
I was taking the TB off of the manifold, when the
upper right bolt started getting hard to turn, and
then it just started spinning.
Looking more closely at the bolt, I found that the
bushing (that is set into the plastic mounting area on
the manifold) is just spinning in place.
Any ideas what I can do to save it, get the bolt out,
and make the bushing stop spinning?
Thanks for any and all info!
Kyle
This archive was generated by hypermail 2b29 : Tue Oct 02 2007 - 15:23:18 EDT