In case anyone is wondering, the answer to my question is 1/4" 12-point.
James
At 10:43 AM 10/1/2007 -0400, you wrote:
>Good day all!
>
>I have a rear end out of a 95 Dak 4X4 that I'm trying to disassemble for
>the Sure-grip center section and the 10" brakes. I re-built the 8-1/4"
>rear in my 91 Dak a few years ago, so I have all the special tools for
>setting it up....or so I thought. Anyhow, I pulled the cover off this rear
>and drained the lube and was just about the pull the cross-shaft pin out
>when I realized it's not a standard bolt head. I searched through all my
>tools, I don't have anything that will fit this, it looks like an external
>Torx or a 12-point bolt head. Can anyone tell me what I need for this? I
>can't even get a small pair of vice-grips in to turn this thing out.
>
>Thanks!
>James
>
>
>__________ NOD32 2562 (20071001) Information __________
>
>This message was checked by NOD32 antivirus system.
>http://www.eset.com
>
This archive was generated by hypermail 2b29 : Thu Nov 01 2007 - 00:07:06 EDT