I had to use a air hammer to get mine lose. took the whole knuckle off
then after a couple of taps with the air hammer it broke free.
On Nov 25, 2007 5:23 PM, Terrible Tom <silvereightynine@aol.com> wrote:
>
> DAKSY wrote:
>
> > Hey, DML...
> > I give up...Can't get the freekin wheel bearing/hub assemblies out of the
> > DAKSY...gonna take the ball joint press back to AZ...
> > However, not all is lost...I AM the proud owner of a pickle fork!
> > Think I'll take the Sporty out for a last chance ride & get the fuel
> > stabilizer in & hook up the battery tender...
> > I'll make an appointment this week with the local indy ...at least he gets
> > to work in a warm garage...
> > WTF...it's only money, dammit...
> > Later,
> >
>
> You should not need to pull the hub/bearing units off Bob. then agian
> thats a Gen IIi so I guess i can't say for positive. But on the Gen I
> and II's ya can change ball joints with teh bugger on there still.
>
> --
> ------------------------------------------------------------
> Join Team DML! SET@Home http://tinyurl.com/32g3qj
> ------------------------------------------------------------
> TerribleTom - AIM & Yahoo: silvereightynine
> http://www.myspace.com/silvereightynine
> http://members.aol.com/silvereightyninej
> ------------------------------------------------------------
>
>
This archive was generated by hypermail 2b29 : Tue Dec 04 2007 - 17:27:37 EST