RE: heater and defrost fan and control

From: Robert Setree (agm@agm.win.net)
Date: Mon Jan 21 2008 - 12:26:28 EST


Good info. My wiring harness had burn up before and I have spade terminals
on my wires plugging into the resistor bank. I can get some use from this.

-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of David Gersic
Sent: Sunday, January 20, 2008 8:16 PM
To: dakota-truck@dakota-truck.net
Subject: Re: DML: heater and defrost fan and control

On Sunday 20 January 2008 05:54 pm, Robert Setree wrote:
> No speeds work. I have voltages on some terminals. I will take it loose
> and look at the windings.

http://www.zaccaria-pinball.com/temp/im005442.jpg

The black one on the left is the original I pulled out. I had only high
speed
working, so there was at least some of the resistor wire intact, but the
other taps were beyond the open.

The green one on the left is the replacement.

http://www.zaccaria-pinball.com/temp/im005443.jpg

The left two terminals are common. The three on the right have different
resistance readings with a meter, leading to four total fan speeds.



This archive was generated by hypermail 2b29 : Fri Feb 01 2008 - 01:11:51 EST