I unscrewed the resistor bank and it is burnt up. The 50 amp fuse did not
blow. The auto parts store I use said they do not have that part and it is
probably a dealer only part. Do any of you have a part number or supplier
for the resistor bank?
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Bernd D.
Ratsch
Sent: Tuesday, January 22, 2008 3:14 PM
To: dakota-truck@dakota-truck.net
Subject: RE: DML: heater and defrost fan and control
They are interchangeable....you don't have the factory connector? (But
yes...you can use properly fitting spade terminals).
- Bernd
-----Original Message-----
From: Robert Setree [mailto:agm@agm.win.net]
Sent: Tuesday, January 22, 2008 1:49 PM
To: dakota-truck@dakota-truck.net
Subject: RE: DML: heater and defrost fan and control
Are they interchangeable if I am willing to put spade terminals on the
existhing wires?
-----Original Message-----g
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of Bernd D.
Ratsch
Sent: Monday, January 21, 2008 6:06 PM
To: dakota-truck@dakota-truck.net
Subject: RE: DML: heater and defrost fan and control
Yup...the newer (ceramic) ones don't burn up like the older resistor boards.
- Bernd
-----Original Message-----
From: Robert Setree [mailto:agm@agm.win.net]
Sent: Monday, January 21, 2008 11:26 AM
To: dakota-truck@dakota-truck.net
Subject: RE: DML: heater and defrost fan and control
Good info. My wiring harness had burn up before and I have spade terminals
on my wires plugging into the resistor bank. I can get some use from this.
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of David Gersic
Sent: Sunday, January 20, 2008 8:16 PM
To: dakota-truck@dakota-truck.net
Subject: Re: DML: heater and defrost fan and control
On Sunday 20 January 2008 05:54 pm, Robert Setree wrote:
> No speeds work. I have voltages on some terminals. I will take it
> loose and look at the windings.
http://www.zaccaria-pinball.com/temp/im005442.jpg
The black one on the left is the original I pulled out. I had only high
speed working, so there was at least some of the resistor wire intact, but
the other taps were beyond the open.
The green one on the left is the replacement.
http://www.zaccaria-pinball.com/temp/im005443.jpg
The left two terminals are common. The three on the right have different
resistance readings with a meter, leading to four total fan speeds.
This archive was generated by hypermail 2b29 : Fri Feb 01 2008 - 01:11:51 EST
