You could tap into the MDS control circuit (C3 "Black" connector at PCM -
Pin #6: Brown/White Wire - MSD Solenoid #1) but I'm not sure how the PCM
will react with a slight change in resistance on the MDS control side. It's
not going to be activated in stop and go, city, or short highway runs
though.
- Bernd
-----Original Message-----
From: Steve Preston [mailto:steveophonic@yahoo.com]
Sent: Saturday, February 02, 2008 8:31 PM
To: dakota-truck@dakota-truck.net
Subject: DML: MDS "on" LED...
Hey DML! Is it possible to find some source of
voltage,either 5V or 12V,that is present only when the
MDS system is operational on a Hemi? Anybody know
where such a source might be easily found? I want to
tap into that with a resistor and bright blue LED to
mount on the dash,to let me know for sure when I'm in
four cylinder mode.
Thanks!
Steve P.
____________________________________________________________________________
________
Looking for last minute shopping deals?
Find them fast with Yahoo! Search.
http://tools.search.yahoo.com/newsearch/category.php?category=shopping
This archive was generated by hypermail 2b29 : Sun Mar 02 2008 - 02:10:09 EST