Thank you Bernd!! :)
I should go with a red LED,because it won't need as
much current,but I like BLUE! If I feed it through a
1kohm resistor or higher,it should be a negligible
draw,not enough to affect anything.
Thanks!
Steve P.
--- "Bernd D. Ratsch" <bernd@dodgetrucks.org> wrote:
>
> You could tap into the MDS control circuit (C3
> "Black" connector at PCM -
> Pin #6: Brown/White Wire - MSD Solenoid #1) but I'm
> not sure how the PCM
> will react with a slight change in resistance on the
> MDS control side. It's
> not going to be activated in stop and go, city, or
> short highway runs
> though.
>
> - Bernd
>
> -----Original Message-----
> From: Steve Preston [mailto:steveophonic@yahoo.com]
> Sent: Saturday, February 02, 2008 8:31 PM
> To: dakota-truck@dakota-truck.net
> Subject: DML: MDS "on" LED...
>
>
> Hey DML! Is it possible to find some source of
> voltage,either 5V or 12V,that is present only when
> the
> MDS system is operational on a Hemi? Anybody know
> where such a source might be easily found? I want to
> tap into that with a resistor and bright blue LED to
> mount on the dash,to let me know for sure when I'm
> in
> four cylinder mode.
>
> Thanks!
>
> Steve P.
>
>
>
>
____________________________________________________________________________
> ________
> Looking for last minute shopping deals?
> Find them fast with Yahoo! Search.
>
http://tools.search.yahoo.com/newsearch/category.php?category=shopping
>
>
>
>
____________________________________________________________________________________
Never miss a thing. Make Yahoo your home page.
http://www.yahoo.com/r/hs
This archive was generated by hypermail 2b29 : Sun Mar 02 2008 - 02:10:09 EST