On Thursday 08 October 2009 21:00:20 Jamie Calder wrote:
> I have a 408 short block that's been sitting in my shed for about 4 years
> now. My local machinist built it but I got the parts from a Dodge engine
> builder (rods, pistons, cam, crank). In the last few years I've learned by
> reading on different forums that perhaps this persons setup (specifically
> pistons and cam) may not be the best combo. Before I pick up this project
> again, I'd like to know if there's a way to determine what compression
> ratio these pistons have.
Compression ratio involves the crank and rods as well, not just the pistons:
http://www.carcraft.com/techarticles/calculate_compression_ratio/index.html
> I did take pictures if it can help anyone identify these Ross pistons.
Maybe contact Ross? Is there a part number on them or any other identifying
marks you can see?
This archive was generated by hypermail 2b29 : Sun Nov 01 2009 - 00:12:06 EDT