On Oct 11, 2009, at 11:20 , David Gersic wrote:
> Before I go hunting for a shop to rework this driveshaft to flip the
> U joint
> around, is there a reason I shouldn't do this? Does it matter
> whether the
> grease zerk is on the "inside" (closest to the centre of the
> driveshaft) or
> "outside" (closest to the end of the driveshaft)?
The only reason zerk position matters is for grease gun clearance.
You should be able to just pull 4 bolts, drop that end of the shaft,
and get the gun on there with no issue.
Mike
This archive was generated by hypermail 2b29 : Sun Nov 01 2009 - 00:12:06 EDT