jon@dakota-truck.net wrote:
> Bill Pitz <bill@pitz.net> wrote:
>
>> Am I blind? I can't seem to find any reference to removal and
>> installation (or more importantly, torque specs) for the valve covers on
>> a 4.7L in my 2000 FSM.
>
>
> Looks like they are supposed to be 105 in-lbs (Page 9-199, lower
> left hand corner). The installation and removal procedures are on
> pages 9-155 through 9-157.
>
> I hope that helps!
>
>
So the short answer to my question is: Yes. I am blind. Duh.
Thanks Jon :-) Off to RockAuto to order new gaskets. Doesn't look too
terribly bad at all for the left side. As I suspected the right side
will be a bit of a pain in the ass, but oh well.
-Bill
This archive was generated by hypermail 2b29 : Fri Jan 01 2010 - 02:54:40 EST