I have extracted 285 horse power from 3.9L V6.
Modifications include headers, true dual exhaust,
4bbl manifold, 500 CFB Edlebrock Carb, K&N air
filter, Mopar Performance ignition, Accel Coil
and wires, Splitfire Plugs, electric fan, Mopar
Performance Cam, and Mopar Performance valve
springs. The most significant power increase
occured when I blueprinted my cylinder heads.
Specs include 1.94" / 1.6" Chevy valves, bronze
guides,teflon stem seals. I alos spent
approximately 40 hours completing a full port and
polish.
The truck screams.
My next project is 4.11 gears and a posi, followed
by a competition clutch. I am sure the brick will
run low 15's at the track.
If you have specification questions let me know.
--------------------------------------------------------------------------------
(__) ,---------. NOTE: The preceding message was sent via Jaek and
(oo) | :\/: _ _ \ Jon's WWW mail cow gateway. That is to say, the
/-------\/_/ : :: :: : ) person who sent this message could in fact be an
/ | MAIL|| \_ ' '`-'`-'/ anonymous prankster. Even though this message was
* ||"" || \__________/ mailed to you from the cs.fredonia.edu domain, it
^^ ^^ could have been generated by anyone in the world.
Please keep this in mind. Thank you! --Jaek (smit2204) and -Jon- (stei0302)
--------------------------------------------------------------------------------
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:28 EDT