Sorry for such stupid questions but easy as it might sound I always get
the luck of needing somthing extra for such an easy installation.
Anyhow, could you explain a little futher about this "flattened S bolt".
>----------
>From: Jane or Larry Elliott[SMTP:elliott@serv.net]
>Sent: Thursday, March 20, 1997 11:12 PM
>To: 'dakota@ait.fredonia.edu'
>Subject: RE: Re[2]: Tune up
>
>Spacers where? The Edelbrock can fits right on the throttle body, but I
>never checked to see if it would work with the supplied 2" tall paper
>element. I'm going to make a bent (flattened S) bolt for the hold down,
>as Kuk had done on his Dakota to get that gawd awful factory air
>restrictor off the throttle body.
>
>Larry
>elliott@serv.net
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:34 EDT