Re: Valve Cover Oil Baffle Question

From: Sam Parthemer (samp@cts.com)
Date: Wed May 14 1997 - 10:10:18 EDT

Next message: Larry Hill: "Rear axles"
Previous message: mahoneyr@syr.lmco.com: "RE: Re:Re:Re: Calibration of SBEC"
Maybe in reply to: Ned Vogler: "Valve Cover Oil Baffle Question"
Next in thread: Ned Vogler: "FW: Valve Cover Oil Baffle Question"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Not an expert, but when I replace a part with another, I usually
will match - match the parts (new to original). If the oil baffel
was on the driver's side, install it there, if the passenger side,
install it there. The universal fit for the valve covers is typical...

Sam '95 SLT

Next message: Larry Hill: "Rear axles"
Previous message: mahoneyr@syr.lmco.com: "RE: Re:Re:Re: Calibration of SBEC"
Maybe in reply to: Ned Vogler: "Valve Cover Oil Baffle Question"
Next in thread: Ned Vogler: "FW: Valve Cover Oil Baffle Question"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:40 EDT