Re: 1st defect - horn

From: Chip Maurer (chip@unx.dec.com)
Date: Wed Jun 18 1997 - 14:12:51 EDT

Next message: JERRY S DALTON: "Re: MSD"
Previous message: Pat Buthmann: "RE: axle ratio questions"
In reply to: Chip Maurer: "1st defect - horn"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Horn update. I checked the wiring last weekend. The
clip that goes to the horn was being pulled (it was
somewhat short). I re-set the clip. Horn has been
honking fine. This means, I'm back to 0 problems
with my 97. I'm very impressed.

Regarding the horn... Access to the horn on the 97's
is pretty easy, so if I do decide to get LOUDER,
it should be a snap.

-- 
+-------------------------------------------------+
| Chip Maurer       Digital Equipment Corporation |
| chip@unx.dec.com  200 Route 9 North             |
| (908) 577-6195    Manalapan, NJ 07726           |
+-------------------------------------------------+

Next message: JERRY S DALTON: "Re: MSD"
Previous message: Pat Buthmann: "RE: axle ratio questions"
In reply to: Chip Maurer: "1st defect - horn"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:45 EDT