Well, I finally found time to do the install on my MSD 6A. Butt-dyno gives
a "need more input" message. Same improvement as the Moroso plug wires.
Smoothed everything out even more. Top end is even less labored on hard
acceleration. Idle is smoother and start-up is immediate. I'm guessing
I'll feel the *real* improvement by the end of the week when I get the
Truck plugs in with a wider gap. Gotta get a brass cap and rotor too. You
can really hear the spark at the cap. This mod should also help with next
weekends project........the Pilone Throttle Body Injection!! ;^)
*******************************97 Dakota Sport*******************************
sean meldrum
email: Home: spm@c3net.net (list subscription)
Work: sean_p_meldrum@auto.ittind.com
Homepage: http://www.geocities.com/MotorCity/Downs/7875/
Black, 318, 5spd, 3.55SG, reg. cab, 2wd, buckets
"Fresh air by Meldrum"
All exterior vinyl graphics removed
Moroso Blue Max plug wires and Spectre looms
DynoMax Race Magnum Welded. 3" in/out, exiting before axle.
MSD 6A & Blaster 2 coil w/ chrome cover
****************************************************************************
****
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:07:48 EDT