I installed a single cat back system on my 92 4x4 Dak back in 94.....
Went prety well, except at that time they hadnt yet had much call for a
system for a 4x4 V* standard cab and I had to send back for a different
muffler....Gibson was VERY cooperative and I am VERY happy with the system,
a full 4 years later!!
I would recommend Gibson to anyone!!
As far as installation, pretty straightforward...They supplied the necessary
hardware and the whole system hund from stock hangers.....
I did have to cut the original system off tho.....Once an exhaust is run for
more than a few minutes, good luck getting these crimped joints apart.
Hope this helps!!
At 03:09 PM 2/17/98 -0500, you wrote:
>Has anybody installed their own Gibson cat-back system, either single or
>duals? I assume that the new pipes come already expanded for slip fit.
>Will I need a pipe splitter to pull apart the stock pipes (the truck is
>still pretty new)?
>
>Anybody run into installation or clearance problems with the Gibson dual
>cat-back setup when running the drivers side pipe around the spare and
>hitch? Do they supply the additional required hangers and clamps, etc.?
>
>Does flowmaster make a similar kit?
>
>Thanks.
>
>
>jeff
>98 RC 4x2 V8 5spd 3.55SG flares
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:08:14 EDT