Extrude Hone-Headers

From: David Brown (dbrown@mh1.mcis.uchicago.edu)
Date: Wed Mar 04 1998 - 15:51:25 EST

Next message: David Brown: "Re: Delayed introduction"
Previous message: Chris Lang: "Re: TEXAS Dakota/Ram Club"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Pretty expensive from what I understand. You might want to see what you can do
with a Dremel tool or die grinder, flex shaft and a couple or three different
stones. Depends on a lot of things though.

-- 
David Brown          Mailto:dbrown@mh1.mcis.uchicago.edu
          Oldsmobile Mailing List FAQ 4.1 at:
http://www.442.com   OR   http://www.en.com/users/thall
  http://nero.dyn.ml.org/~da_bomb/oldsfaq/oldsfaq.htm
Conserve bandwidth, get the zip file for local viewing:
           ftp://arl.arizona.edu/lists/olds
http://nero.dyn.ml.org/~da_bomb/oldsfaq/zip/oldsfaq4.zip

Next message: David Brown: "Re: Delayed introduction"
Previous message: Chris Lang: "Re: TEXAS Dakota/Ram Club"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:08:20 EDT