JT writes: >>Is there enough material in the cylinder walls of the
Magnum blocks to accomodate boring a 318 out to a 360? Or is it wiser
to short-stroke a 360 block?<<
I'm far from being the resident expert here, so I'll make some comments
that will probably start a flame war. The "A" blocks are thin wall
castings, so I'm assuming that the 318 will not bore out to the 340/360
bore. I would start with the 360 block. These are my plans someday
for the '89. I haven't really started to put anything together yet.
I'm just trying to collect all the information I can, so when I get
ready for the project, I'll have all the information at hand.
If/when I really do it, I will share it with the LIST.
Azie
Ardmore, Al.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:08:21 EDT