Mike, you have an aftermarket dual exhaust system. How do you know that
these sway- bars will work, with your duals? I am wondering b/c I have
duals also, and want rear sway- bars.
Thanks,
Robert
Michael Clark wrote:
> Rader, I'm very near ordering a front and rear Addco sway bar, but one
> quick question about the urethane bushings. Would it be better to buy
> the urethane Addco kit or get the bushings seperately from energy
> suspensions or summit. I want bushings that I can grease because I have
> heard that urethane squeaks pretty bad some times. Do you know if the
> Addco supplied bushings allow you to grease them? If they do I'll just
> get the urethane versions of these bars and kill two birds with one
> stone. If not then I will oder the bushings seperate to get the grease
> fittings.
>
> And on the rear bar, was that a drill on or bolt on.
> Thanks.
> --
> ----
> Michael Clark mike@snakebite.com
> '93 MarkIII 4X2 V-8 SWB RC auto, DDBC
> K&N FIPK, Flowmaster cat-back dual, MP SBEC
> Doug Thorley Headers, Moroso Blue Max wires
> 180 degree thermostat, WaterWetter, Brass cap & rotor
> one and only 1/4 mile time of 15.08 @ 90.82
> My Dakota page=> http://web.wt.net/~mclark/dakota.html
> Dakota Webring=> http://web.wt.net/~mclark/webring/ring.html
-- Mailto:rotrottmann@davidson.edu http://thelma.davidson.edu/rotrottmann/web/default.htm Davidson, NC- Now St. Louis, MO- May 19th 95 Sport 318 Auto 2WD
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:08:25 EDT