The pulley should have a bolt right in the center of it. Take a wrench and
put it on the bolt and turn clock wise as if trying to tighten the bolt.
This should move the tensioner to allow for belt removal. You may want to
use a ratchet for this job.
Good luck.
----------
> From: Bob DeChance <kbshadow@email.msn.com>
> To: dakota-truck@buffnet.net
> Subject: DML: Belt tentioner
> Date: Sunday, May 10, 1998 10:24 AM
>
> I have to change the belt on my wifes car, it has a belt tentioner round
> wheel that applies presser to belt to keep it tight.
>
> Looking at it I can not figure out how to release it to take the tention
off
> the belt.
>
> Any tips would be welcome .
>
> Thanks
> Bob DeChance
> Stockton Ca
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:08:46 EDT