Re: Re: intake work

From: Jon Steiger (stei0302@cs.fredonia.edu)
Date: Fri May 22 1998 - 16:44:59 EDT

Next message: James Henry: "M1 Intake"
Previous message: Ayotte, Glen: "RE: Keyless/Factory alarm(scott)"
In reply to: Sean_Meldrum@ittauto.com: "Re: intake work"
Next in thread: Kabuki2: "Re: Re: intake work"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

On Fri, 22 May 1998 Sean_Meldrum@ittauto.com wrote:

> >everything thats been done to the 360 is off of the 318! Sad to say, I
> >haven't had the funds to do what I want. But I have true duals on it,
> some
> >homemade intake work<snip>
>
> What did ya do? Just polish and knife edge everthing? Reduce the
> plenum volume by boxin' it off?
>

I understand polishing and knife edge, but what is meant by
"boxing it off"? (Also, what is a plenum, and why would you want
to reduce its volume?)

Thanks! :-)

-Jon-

  .--- stei0302@cs.fredonia.edu ------------------------------------.
  | DoD# 1038, EAA# 518210, NMA# 117376, USUA# A46209, RP-SEL |
  | '96 Dodge Dakota v8 SLT CC (15.34@89.10), '96 Kolb FireFly 447 |
  `----------------------- http://www.cs.fredonia.edu/~stei0302/ ---'

Next message: James Henry: "M1 Intake"
Previous message: Ayotte, Glen: "RE: Keyless/Factory alarm(scott)"
In reply to: Sean_Meldrum@ittauto.com: "Re: intake work"
Next in thread: Kabuki2: "Re: Re: intake work"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:08:49 EDT