In a message dated 98-06-03 07:20:12 EDT, you write:
<< It is possible that everyone is right. There may be enough tolerance in
the
body, engine mounts, frame etc that there is a +/- 1/4" tolerance between
Daks.
Some may fit and some may not. >>
What about engine movement as when torque twist, how much room has to be
allowed for that. I mean it could fit fine with engine off but when WOT under
load the engine will twist but how much ???
Bill
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:08:54 EDT