>The two grease zerks that I found are on the front lower ball joints, one
>each side (I wasn't very clear about that in my original post, sorry). The
>front upper ball joints seem to be sealed. Anyone else know where any
>more are? Are there any more?
>
>Steve
These are the only two I've found (or actually was shown). After my free
3,000 mile oil change and lube, one of my friends ( a gearhead in a former
life) was gonna show me ( I do know the basics of internal combustion,
that's about it) how to check to see if they needed lubed.
Well, the dealer had been kind enough not to dirty up the fittings by using
them. The resivoirs were empty. Is this typical after 3,000 miles or did CC
not fill them when it was built either? (Nothing looked leaky or anything,
everything was too squeaky clean!)
Regards,
George
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:09 EDT