Perfect time to check the valve lash - while the covers are already
off!!
Wires? Magnecor. You'll pay a little more, but from what I've
heard...... spend it. Cost you $99.00.
Tate
-----Original Message-----
From: Michael Clark [SMTP:mike@snakebite.com]
Sent: Saturday, August 08, 1998 7:59 PM
To: DML
Subject: DML: MP valve covers
Just wanted to let everyone know I recieved my valve covers
yesterday.
Man these things are Beeeuuutiful! I took a bunch of photos of the
covers and the install process so later on I'll do a write up and
post it on the DML page. So far I've only been able to put one
cover
on because I'm waiting to get the grommet set for the pcv valve. So
now I'm running around with a stock cover on the passenger side and
the MP one on the drivers side. At least I've got the difficult one
taken care of.... Also I tried to use the stock studs
for the wire looms but they were too short, the threads wouldn't
reach far enough into the head to screw down, so I'll have to get
some aftermarket wire looms. Oh, and another thing, I'm pissed at
Moroso. 5 of
my eight wires pulled off of the connector when I was taking them
off
the plug. I pulled on the boot (not even real hard) and they just
slipped right out! These were factory crimpped! So any suggestions
on some good wires? I had to
reuse some of the stock ones, so my engine looks REAL funky now --
two different valve covers, 5 stock wires 3 Moroso wires, stock
manifolds..... Oh well, I guess I'll have to go to church tommorow
for all the cussing I've done in the last few days!...
---Mike, near Houston.---
My sig file=====> http://web.wt.net/~mclark/signature.txt
My Dakota page==> http://web.wt.net/~mclark/dakota.html
Dakota Webring==> http://web.wt.net/~mclark/webring/ring.html
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:19 EDT