In a message dated 98-08-08 16:59:35 EDT, you write:
<< I'm sure some type of small puller could handle this job of getting it
off. As for getting the new one on, probably just getting the bolts
started and letting them "pull" the thing on as you cinch them down. I
can't imagine that the interference fit is all that tight in this
application.
Bob >>
There are NO capscrews on the front of the pulley to remove or to use to pull
on the new pulley.
Steve in Houston
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:19 EDT