RE: JBA's & Copper RTV?

From: Bridges, Bruce (bbridges@alarismed.com)
Date: Thu Aug 20 1998 - 16:06:02 EDT

Next message: Chris lang: "Re: Re: Re: Motor Trend (R/T Special)"
Previous message: Stephan Boianoff: "JBA's & Copper RTV? -Reply"
Maybe in reply to: RAS*002@worldnet.att.net: "JBA's & Copper RTV?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Russ,
For the head pipe seals I used Permatex copper loaded silicone the read
"sensor safe" on the tube. Its a matter of VOC degree. the old RTVformulas
had lots of acetic acid outgassing during cure but were mostly reformulated
for "todays" cars.
Bruce

-----Original Message-----
From: RAS*002@worldnet.att.net [mailto:RAS*002@worldnet.att.net]
Sent: Thursday, August 20, 1998 12:41 PM
To: dakota-truck@buffnet.net
Subject: DML: JBA's & Copper RTV?

  I'm preparing to install my JBA's next week, and would like some
advice on the gasket sealer ya'll are using. I seem to remember
something (years ago) about RTV being detrimental to the O2 sensors.
Has this changed? Or are you doing it regardless, and just not having
any problems?

                Thanks,

Russ Selkirk

-- 
'96 Black Impala SS
'85 Silver Monte SS
'98 Amethyst Dakota RC R/T 
 - Port Neches,Texas
=================================
NOTE:   Anti-Spam Address! Please
reply to: RAS002@worldnet.att.net
=================================

Next message: Chris lang: "Re: Re: Re: Motor Trend (R/T Special)"
Previous message: Stephan Boianoff: "JBA's & Copper RTV? -Reply"
Maybe in reply to: RAS*002@worldnet.att.net: "JBA's & Copper RTV?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:23 EDT