Donny,
I used permatex spray on copper coat for the manifold to head gaskets and
high temp copper silicone for the head pipe joints. watch out for the right
side O2 sensor, you may want to remove it to tighten the flange up!
Good luck!
Bruce
-----Original Message-----
From: Donny M Hayes [mailto:hayesdm@scott.net]
Sent: Tuesday, August 18, 1998 7:24 PM
To: dakota-truck@buffnet.net
Subject: DML: GOT MY HEADERS!!!!!
smooth joints, ports look nice and clean. A couple of clamp marks is all I
see and I can live with that. I can't wait to get them on.....they look so
good ...wooohooo!
Hope my install goes as well as some of the others, what type of sealant are
you all using? Copper RTV?
Anything else?
Can't wait for the weekend....Thanks again Jack for getting this deal
together.
Donny M Hayes
1998 Dakota RT 5.9 CC Amethyst
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:24 EDT