Yeah but why are you guys lossing power (time). Is there an actual
reason why the stock ignition system is better than if I was to go out
and buy an high proformance set. I dont know about the rest of you but
I like to do some research on something before I spend my money on it.
Fleg
----Original Message Follows----
Date: Tue, 25 Aug 1998 17:24:00 -0600
From: GSWillhite <GSWillhite@ualr.edu>
Subject: DML: Re:Any Gains in Electrical mods
To: dakota-truck@buffnet.net
Reply-To: dakota-truck@buffnet.net
Duff, I think Jacks right. I remember some threads on
MSD ignitions loosing some power (time) through the 1/4
mile, I believe it was Bill Tier who lost .2 in a pretty
solid test at the track.
Think I'm gonna just buy some BIGGER wires, may get in
on this Magnecore deal.
GS
>
> Date: Tue, 25 Aug 1998 15:19:25 -0400
> From: "W. Jack Hilton III" <hemi@mindspring.com>
> Subject: DML: any gains in electrical mods ?
>
> >Performance wires, while probably adding a little, don't help out too
much
> >until you start to increase your spark energy (ie: install a
performance
> >ignition setup).
>
>
> I remember a heated discussion a few months back in which it was
determined
> by more than a few that they actually saw a LOSS in performance when
they
> switched to a "performance" ignition system .
>
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:27 EDT