Well it's 2:44 am sunday and I just got done lowering my Dakota.
I used 2" blocks on the rear and cut 1 coil off the bottom of each
spring on the front, this gave me 1 3/4 drop in the front. I had to cut
a little off of the stock bumpers also. Everything went as planed, rides
very good and handles the same if not better than before ( no bump steer
that I can tell ). I didn't even have to remove the spring in the front
to cut the things, just compressed it enough to turn it around and got
the old cut of tool out and that's it. This may not be the best way to
do it but hell for $20.00 and a few hours, why not.
Any way man did it make the thing look good.
Got to go
Colin H.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:28 EDT