I guess I am going to go out and get me a good core so you can work me up one
of these monster TB's. I don't have the time to play with mine
Colin
Holloway,Frank T wrote:
> DML,
> Here is where we are at with the TB's. The first one that Bruce installed
> appears to be working fine (no check engine light, or dead spots off idle).
> The next will
> have larger thinner brass throttle plates and a stainless steel throttle
> shaft installed. Hopefully he will be installing the new one the weekend of
> Sept 12th. I will be
> installing one identical to the new one for Bruce this coming weekend. Bruce
> had some concerns about interference with the manifold and larger throttle
> plates,
> and I need to check this out on my truck (see if it is unique to Bruce's
> truck), flow numbers will follow. Additionally, I'll be running my truck on
> the dyno to check
> for power and lean conditions. If everything goes according to plan, we
> should have some additional numbers next week. Cost, we don't know yet but
> were kicking
> around a figure between $50 - $100 each, what do you think????
> Frank
>
> > -----Original Message-----
> > From: DodgeBoyz3@aol.com [SMTP:DodgeBoyz3@aol.com]
> > Sent: Monday, August 31, 1998 3:42 PM
> > To: dakota-truck@buffnet.net
> > Subject: Re: DML: RE: RE: franks TB!!RE: Magnum Performance Throttle
> > Body?
> >
> > In a message dated 8/31/98 4:23:34 PM Central Daylight Time,
> > AMok@spbank.com
> > writes:
> >
> > > How much and how do I contact Frank?
> > Ahhhh........ make that two of us!
> >
> > Gene
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:43 EDT