In a message dated 98-09-01 14:13:52 EDT, you write:
<< Bruce,
I was thinking about this one last night.
I washed my truck on Saturday and the roughness started right
afterwards. You washed yours and the JET went bye-bye. Connection or
coincidence?
I pulled the chip last night and it idles much better. Haven't felt the
surging either. The truck is in the shop for the lowering job at the
moment, but I plan to give JET a call today and see about a replacement.
Bob >>
Hey guys,
As posted earlier this week, I also had a problem with my R/T cranking without
starting and after pulling the Jet it started. Frank suggested I plug it back
in before sending it to Jet which I did and bingo, it started right off and
runs with the improved drivability I remember when I first installed it. I
think the problem is the module was not pushed all the way into the computer
and it worked its' way out slowly, disengaging the pins over a period of time.
At least I hope that's it.
Regards,
Steve Waller in Houston
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:44 EDT