Ok I measured my anit sway bar and it is 15/16 of an inch thick, or 24 mm
thick. I decided that I do want to get the greasable ones.....I have run into
some problems though. Ok I have a total of 4 bushings, 2 on the frame and 2 on
the lower control arm. I have noticed in a catalog I have the there are small
sizes and full sizes. The lower control arm bracker from the center of one
bolt to the center of the other is 2 5/16 inches, so according to the chart, I
need a small size kit for the 2 arm bushings, which they list the minimum size
for the bracket hole is 2 1/16 with a max of 2 7/8, so of course I will need
the small ones for the 2 arm bushings. And these do not bolt in , they are
more like self taping screws, not bolts. Did you know if you did order the
small ones???? Now the frame mounted 2 is another story. From the center of
the bolt to the center of the other bolt is 3 7/8 inches. These are bolted on,
not screws like the arm bushings. Here is the major problem I
encountered.....the max hole to hole distance can be 3 5/8 inches for the
largest bracket, was yours like this??????? Since mine is 1/4 longer than the
bracket, I dont think I could use this!!! Please help, sorry for the long and
confusing mail!
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:09:57 EDT