In a message dated 98-09-27 11:59:54 EDT, you write:
<< I posted a message a few days ago but never got any replies...I need the
screws that hold the license plate holder to the bumper on the front of a
97+ Dak...Is this a part that a Dodge dealership can order for me? If not,
what dimensions are the screws? I looked at the hardware store but couldn't
figure out which would fit. >>
Hey Ben,
I thought I gave you the length last night. Well went out again and measured
its 3/4 of an inch long and the head is a little under 1/2 inch wide. If you
have the screw for the rear license plate, I think they are exactly the same
or somewhat close. Hope this helps.
Later,
2me
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:10:06 EDT