I have a set of Mopar headers that I used on my 98 5.2 that were made for a 97 and
they fit perfectly. 97 and 98 and 99 all the same. BUT 96 back is a completely
different truck but the 5.2 l engine is the same since 93 I think. I am not clear
on where the problem was. Did the fit the heads OK and hit something on the
body? Also many use the JBA headers and they seem to fit OK. Hope I was some
help.
Jim in Waco.
98 RC 4X2 5.2 Auto
BlKV8Dkota@aol.com wrote:
> Ok here is my story. I purchased Summit truck headers made by flowtech for my
> 98 318 dak. In the catalog theyt sat only 96-97 so i called and asked if they
> would apply to 98's they told me to call flowtech and ask. So I did. Their
> techs said nothing changed from 97-98 so they shall fit so I ordered them.
> Well when they got I here I was woried because the last pipe cam up and over
> the top of the headers wich looked like a clearence problem. So I e-mailed
> flowtech to make sure they would fit and they assured me they would. Well
> today i spent 3 hours and no go so I am stuck with the manifolds and no
> headers and i am Pissed. So please for the love of god dont listen to
> flowtech. So here is my present problem. I am returning the headers to
> summit and getting my 160 back. What should I purchase now? I have an Airaid
> and a 180 thermostat and that is it. Dont want a chip yet, dont want to have
> to run 93 gas. It is a daily driver son nothing to extreme like nitrous.
> should I get exhaust, find new headers, throttle body, ud pulleys or what
> please give me suggestions along with prices. thanks
>
> Josh
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:10:40 EDT