Thought some of you guys/gals might be interested in this.I went to Home
Depot and bought a 3" Clamp type rubber 90 degree elbow. I cut the 3" end
off of one side and the size that was left was a perfect slip fit over the
stock air collector (bolted to the carb). Then I cut the elbow aprox in
the center (cut it a couple of times to get the right angle). Connected it
to a piece of 3" PVC (after cleaning off the lettering with some acetone)
Tomorrow I'm gonna pick up a K+N to fit over the 3" PVC and Walla home
grown HP Air Inlet for the cost of $10 elbow, free pc of PVC, and the cost
of the K+N. What do ya think???? Anybody have a K+N catalog that has the ID
of the K+N inlet? I'll need one with a 3 1/2" inlet or I can bush down.
Bob
--------------------------------------------------------------------------------
(__) ,---------. NOTE: The preceding message was sent via Jaek and
(oo) | :\/: _ _ \ Jon's WWW mail cow gateway. That is to say, the
/-------\/_/ : :: :: : ) person who sent this message could in fact be an
/ | MAIL|| \_ ' '`-'`-'/ anonymous prankster. Even though this message was
* ||"" || \__________/ mailed to you from the cs.fredonia.edu domain, it
^^ ^^ could have been generated by anyone in the world.
Please keep this in mind. Thank you! --Jaek (smit2204) and -Jon- (stei0302)
--------------------------------------------------------------------------------
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:10:41 EDT