Is there a webpage for Hennesey with some product info? I would like more
information on them to see if they have stuff for the later model dakotas.
Joel
-----Original Message-----
From: ChrisQC1@aol.com [mailto:ChrisQC1@aol.com]
Sent: Tuesday, December 01, 1998 6:08 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: Kenne-Bell Web Page-reply
In a message dated 98-12-01 19:32:47 EST, you write:
<< Is it a direct replacement for your stock comp?
Plug in like the JET chip. >>
It appears more and more like many new "computer's" for OBD2 systems may be
inline. Even Mopar Performance has eluded to the possibility of this for the
next generation units. The Kenne-Bell unit is an independent processor which
reprograms, tunes, and optimizes fuel and spark curves. It sounds cool, call
em and find out.
The Kenne-Bell unit, is an advanced piece of hardware, similar to the stuff
Hennesey is doing at an even higher cost. I'm not going to justify the cost
here, that's Kenne-Bell job, hell, I don't think I can afford one, but this
is cutting edge programming currently being used as standard equipment in
the
Sheby Durango. All computer modifications for OBD2 controlled vehicles have
been slow to surface.
Oh, and for what its worth, they are sealed units which may even allow us
Jet
guys to wash our trucks again.
Chris
1998 R/T CC
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:11:21 EDT