At 11:04 AM 12/5/98 -0500, you wrote:
>The stock MP Magnum casting can be had for around $119.00 ea. It utilizes the
>1.92 int. & 1.625 ex. valves.
>
Are those the same size as the stock 318/360 valves? (i.e. would
there be any benefit to bolting on those heads as is?)
And speaking of which... What is the difference between a casting and
a head? If someone were to buy a couple of the above casting to have
them ported, what additional stuff would have to be purchased or done
before they could be bolted onto the engine for some fun runs? :-)
-Jon-
.--- stei0302@cs.fredonia.edu ------------------------------------.
| Affiliations: DoD, EAA, MP Race Team, NMA, SPA, USUA. RP-SEL |
| '96 Dodge Dakota v8 SLT CC (14.58@93.55), '96 Kolb FireFly 447 |
`----------------------- http://www.cs.fredonia.edu/~stei0302/ ---'
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:11:23 EDT