In a message dated 12/7/98 6:06:44 PM Eastern Standard Time,
jeanninemike@fuse.net writes:
<< This treatment wouldn't work
for my other spots, so they're replacing them. >>
This is a vendor problem that CC has had in the past. The part when it is
being made is over heated in the mold at the clip points and is a little too
thin therefore leaving lite spots. We have had that problem recently in the
Design studio for Jeep interior parts and pointed it out to the vendor which
is taking care of the problem hopefully for good!
Eric
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:11:23 EDT