In a message dated 98-12-21 00:31:19 EST, you write:
<< Just out of curiosity, why would you want to fabricate an aluminum plate
and
weld it to the underside of the manifold when a decent gasket will do the
job. The gasket that Jim Bell sells has been tested at 30 PSI and holds up
fine. Seems like a lot cheaper way to go and allows for future changes in
the intake cavity. The heat shield is a good Idea.......
Frank >>
That would be better then welding it up for sure.
Brad
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:11:29 EDT