----------
> From: eric neidhamer <bad318@yahoo.com>
> To: dakota-truck@buffnet.net
> Subject: DML: O2 sensor tip.. good one, read it.
> Date: Tuesday, January 12, 1999 10:18 PM
>
> I noticed all the cut outs for the O2 sensors.. If you plan on doing
> exh work that required new O2 fittings go to a local parts store (Auto
> Zone around here) and get a "spark plug fouler" they are about 3.50 or
> so.. all you have to do it cut off the lower section with a hack saw.
> .get the exh shop to weld this on the pipe. This is much cheaper than
> the ones you order and works 100% as well.
>
> Eric - '97 318 Dak.. <14.5's
this is helpful info eric... but should include fact that welding can cause
threads to shrink... so use an old plug... most are 13/14 mm? same as o2...
as a heat sink. :)
jam'n
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:11:57 EDT