Nope , needs four holes instead of two , kinda like trying to squeeze a
square through a round hole .
At 02:18 PM 1/21/1999 -0500, you wrote:
>can you use the stock intake manifold with the 4bbl Tb?
>
>
>"Holloway,Frank T" wrote:
>
>> DML,
>> I just picked up the 4 BBL TB and it is quite an amazing piece of work. The
>> TB is machined from a solid piece of aluminum. Bore diameter is 1.686
and it
>> has an IAS, TPS and a MAP. The MAP is located in the exact same place as
the
>> factory 2 BBL MAP, the TPS is located on the back barrel throttle shaft
and
>> the IAS is located just in front of the TPS. The linkage is a work of art,
>> but the throttle stops don't look like they will hold up to the rigors of
>> daily driving (SS cap screws that come to rest against the aluminum
>> linkage). There were no brackets to hold the factory throttle cable and no
>> provisions to bolt up the factory bracket, so the linkage is going to take
>> some work. The throttle bores a fully machined, heck, the whole thing is
>> fully machined. Throttle shafts are half-shafts, just like what we are
>> installing, and the plates are aluminum. A beautiful example of CNC
>> machining. Next comes the manifold.......
>>
>> Frank
>
>
>
----------------------------------------------
Jack Hilton III
Black 1998 Dodge Dakota R/T Club Cab
Charter Pipeline......the Next Wave.....
http://webpages.charter.net/hemi/jbd1.html
----------------------------------------------
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:10 EDT