can you use the stock intake manifold with the 4bbl Tb?
"Holloway,Frank T" wrote:
> DML,
> I just picked up the 4 BBL TB and it is quite an amazing piece of work. The
> TB is machined from a solid piece of aluminum. Bore diameter is 1.686 and it
> has an IAS, TPS and a MAP. The MAP is located in the exact same place as the
> factory 2 BBL MAP, the TPS is located on the back barrel throttle shaft and
> the IAS is located just in front of the TPS. The linkage is a work of art,
> but the throttle stops don't look like they will hold up to the rigors of
> daily driving (SS cap screws that come to rest against the aluminum
> linkage). There were no brackets to hold the factory throttle cable and no
> provisions to bolt up the factory bracket, so the linkage is going to take
> some work. The throttle bores a fully machined, heck, the whole thing is
> fully machined. Throttle shafts are half-shafts, just like what we are
> installing, and the plates are aluminum. A beautiful example of CNC
> machining. Next comes the manifold.......
>
> Frank
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:09 EDT