Ok fellow DMLers, I am just wondering about something, and hopefully wondering this
for no reason at all, but I need to ask. Am I going to run into any problems when upraging
from my 7MM(7.5MM?) ignition wires to 8.5MM wires as far as the dist.cap connectors are
concerned? I guess what I am asking is will these 8.5MM wires still 'lock' onto my brass
connectors on my Borg Warner Select dist.cap securely, since I am using a larger wire?? Just want to make sure that these will work before I order them from a local speed shop.
I plan on using MSD Super Conductor 8.5MM wires listed for a 94-97 V8 Ram(#33189) even thoughI have a V6 Dakota, just will have 2 extras. Thanks to those of you who
suggested to use this part number.
Thanks again,
Kyle
93 Dakota 4x4 V6
--------------------------------------------------------------------------------
(__) ,---------. NOTE: The preceding message was sent via Jaek and
(oo) | :\/: _ _ \ Jon's WWW mail cow gateway. That is to say, the
/-------\/_/ : :: :: : ) person who sent this message could in fact be an
/ | MAIL|| \_ ' '`-'`-'/ anonymous prankster. Even though this message was
* ||"" || \__________/ mailed to you from the cs.fredonia.edu domain, it
^^ ^^ could have been generated by anyone in the world.
Please keep this in mind. Thank you! --Jaek (smit2204) and -Jon- (stei0302)
--------------------------------------------------------------------------------
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:13 EDT