about the filter drooping, you should rotate it every so often. It is
not necessarily the heat causing the droop, but possibly the weight of
the filter. I rotate my filter every so often and it hasnt touched
anything. You could also just loosen the upper hose clamp on the TB
inlet and rotate the pipe a little so that the filter sits higher off
the horn. Hope it works...let me know...Tony D
GSWillhite wrote:
> For you DML'ers with the 3inch metal tubes for FIPKs, Pepboys
> sells a large foil covered mat for underhood insulation at
> $19.95. I've noticed my 3" pipe gets mighty hot, especially in
> the summer.I'm thinking of wrapping the tube to keep the air
> intake cooler. The heat is causing my K&N cone to droop down and
> ride on the horn, wearing a small hole. I bought some aluminum
> tape at Home Quarters to seal everything up. Hope it works, I've
> relocated the horn.
>
> GS -
>
> Ps - epoxy did a good job on sealing the damaged wire frame on
> the K&N.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:34 EDT