I used the #30 to take off the piece that holds the throttle cables. I'm not
100% sure but the IAC was the #25, the map used the #20 and I dont remember
what the TPS used . I'll take a look at it tomorrow since its dark,
freezing and snowing like crazy at the moment
Chris
-----Original Message-----
From: Bridges, Bruce <bbridges@alarismed.com>
To: 'dakota-truck@buffnet.net' <dakota-truck@buffnet.net>
Date: Friday, February 12, 1999 6:19 PM
Subject: RE: DML: Torx omission was: Finally installed my TB
>OOps,
>Never did actually do an install on a 93... Ill print your email and
update
>the instructions! Which torx were used on which components? (96-99 use
>only the #20...)
>Bruce
>
>-----Original Message-----
>From: Chris lang [mailto:langcj@clarkson.edu]
>Sent: Friday, February 12, 1999 3:43 PM
>To: dakota-truck@buffnet.net
>Subject: Re: DML: Finally installed my TB
>
>
>For my 93 I used #20, #25 and #30 torx drivers. There's a listing of the
>tools needed in for the install and the #20 torx is in there but I needed
>the other two to get everything off on my 93. Besides that all you need is
>a 5/16" box wrench, a 1/2" socket and a 3/16" allen wrench. I went out and
>bought the torx drivers for around 3 bucks each at western auto.
>
>Chris
>
>
>
>-----Original Message-----
>From: Patrick Delgado <dadoctah@worldnet.att.net>
>To: dakota-truck@buffnet.net <dakota-truck@buffnet.net>
>Date: Friday, February 12, 1999 4:52 PM
>Subject: Re: DML: Finally installed my TB
>
>
>>Torx drivers? oh-oh. I had planned on installing mine in the post office
>>parking lot when it came in.
>>What tools are needed for the B&F TB R&R?
>>Dr. Pat
>>
>>----------
>>>From: Chris lang <langcj@clarkson.edu>
>>>To: dakota-truck@buffnet.net
>>>Subject: DML: Finally installed my TB
>>>Date: Fri, Feb 12, 1999, 8:46 PM
>>>
>>
>>> It was somewhat warm outside today so I decided it was time to finally
>>> install my B&F TB. After getting the right size torx drivers the
install
>>> went without a hitch and was quite easy, thanks to the instructions from
>>> bruce. Since it started raining during the install I didn't get a very
>>> good test drive in but there was still a noticible difference in the
>>> throttle response. I can't wait till the roads dry a bit to really
punch
>it
>>> to see what I've got. Thanks again Bruce and Frank, you get my TB in
the
>>> mail in a few days along with my check. I'll try to clean it up a
little
>>> before sending it since its looking a little nasty at the moment...
>>>
>>> Chris
>>>
>>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:35 EDT