Jason:
The tool is actually two pieces of steel, one of which clamps into a bench
vise, and the other piece which you hit with a hammer. When the two pieces
are together, there is an opening in the center of them which is only slightly
smaller than the diameter of the plug wires themselves.
Again, the "lower" piece fits in a vise, then you put the plug wire, with the
core folded back, and the connector on the wire, onto the lower piece. Then
you put the upper piece on top of the lower, and hit it with a hammer, thus
crimping the connection. I believe they are available from Summit and Jeg's,
if you want to see a picture of one.
Steve.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:38 EDT