Ok, sounds like I know what to do to measure then....
Jason
2/19/99 3:52 PM
-----Original Message-----
From: Jetmugg@aol.com [SMTP:Jetmugg@aol.com]
Sent: Friday, February 19, 1999 1:42 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: Wheel question
The bolt circle actually describes the diameter of a circle
which runs through
the center point of each hole. That is, if you drew a circle
4-1/2" diameter,
then laid out 6 holes, each of which had its center point on the
4-1/2"
circle, you would have a 6 bolt pattern, on a 4-1/2" bolt
circle.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:39 EDT