Jason just keep things simple. 1st, each cyl. will be numbered on the
injector wiring. The plug below each cyl. will be in the
corresponding cyl. 2nd, the distributor terminal for the #1cyl will
have a mark for it (usually a raised 1 in the molding). 3rd, moving
clockwise around the distributor, follow the firing order. The firing
order will be cast into the intake manifold, in front of the throttle
body (you may need to remove the air intake hat to read these)
That's pretty much it, just make sure the #1 dist. terminal goes to
cyl #1 and then work your way around the distributor in a clockwise
direction.
==
Jon Smith -- NC
'95 CC SLT 4x4
318 auto, MP comp, JBA headers, 8.5mm MSD wires, 14x3 K&N, dual cat-back glasspacks, 180 degree thermo, spectre wire dividers
ICQ # 9720504
_________________________________________________________
DO YOU YAHOO!?
Get your free @yahoo.com address at http://mail.yahoo.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:12:44 EDT